Two Rock Classic Reverb Signature Sliver Front Panel 100/50 ~ Due May 2022

Reward Points Earn 4699 points for this item
Applies only to registered customers.
Estimate Shipping
Part Number

The single-channel Classic Reverb Signature is Two-Rock’s ultimate tone shaping machine.  Updated in November of 2016 with Bill Krinard’s new design tacticts, this amp is Available as either a 50W (2 x 6L6) or 100W (4 x 6L6) head.   Built on either a black or silver aluminum chassis, this amps has been updated with a new output transformer on the 100 watt models, as well as an added Gain Structure switch for 3 different voicing settings on the input stage.  Extensive tone shaping is offered via Treble, Middle, Bass, Bright, Mid, Deep and EQ controls. A Contour control facilitates switching between single coils and humbuckers while adjusting for room acoustics, without having to change preamp EQ settings. A footswitchable FET preamp stage, eq BYPASS and REVERB DEFEAT are stock features of this versatile amplifier.


Gain Structure: The 3 position gain structure switch changes the sensitivity and overall feel of the preamp.  In the down position, the amp feels similar to a vintage blackface, the middle position is much like the Two-Rock Matt Schofield Signature front end with a hotter input stage, and the full up position is our traditional Two-Rock frontend.

Power Selector: On 50 Watt Models, the HIGH power mode is fixed-bias and the LOW power is cathode biased.  While the Low setting may sound louder, you’ll notice a significant headroom decrease.  On 100 watt (4x6L6) models, the HIGH power mode is100 watts, the LOW power mode is 50 watts.  With the 100 watt Classic Reverb Signature’s output transformer, when switching from 100 to 50 watts, the transformer will compensate for impedance differences so you will not have to change impedances.

– Footswitchable FET preamp stage with level control

– Treble, Middle, Bass, Bright, Mid, Deep EQ controls

– Dual EQ settings

– Gain and Master contour control

– 4, 8, 16 ohm output

Output Power: 50 Watt dual tube rectified, or 100 Watt Head with half power scaling option.

Tubes: 2 x 6L6 (50 Watt) or 4 x 6L6 (100 Watt)

Footswitch: FET, eq BYPASS, and REVERB DEFEAT

Dimensions: 22-3/4″ wide x 12″ tall x 10-5/8″ deep

Weight: 43 lbs.

Speaker Jacks: (2) 4 ohm; (1) 8 ohm

Colors: Black Bronco, Blond, and Black Taurus

Classic Reverb is now the Classic Reverb Signature 

Bill Krinard is back on board at Two Rock and he's made some changes to the Classic Reverb to make it even better than before.

-Upgraded numerous internal components/layout inside of the amp.

-Removal of feedback switching on the rear and reverb selection on the front.

-Available in silver anodize or black anodize, no more faceplates and now a thicker aluminium redesigned chassis. Additional upgrade will include silver skirted knobs.

-Addition of a “gain structure” switch. This will allow you to switch from a Schofield Signature, Sterling Signature, or Traditional Two-Rock front-end.

-New proprietary output transformer designed to properly switch the amp from 50/100 watt mode with improved overall tonal qualities.

More Information
Manufacturer Two Rock
Model Classicrvbsi
Condition New
Weight (kg) 0.000000
Write Your Own Review
You're reviewing:Two Rock Classic Reverb Signature Sliver Front Panel 100/50 ~ Due May 2022