Does It Doom Doomsaw HM-2 Heavy Metal Chainsaw Distortion

£219.00
£219.00
Reward Points Earn 219 points for this item
Applies only to registered customers.
Estimate Shipping
Part Number
DID-DOOMSAW
A gruesome single knob adaptation of the dimed HM-2 chainsaw circuit, we’ve taken the classic death metal tone and tailored it to modern doom, sludge, and drone metal.

Thundering lows, punishing mids, and that unmistakable chainsaw grind, the Doomsaw is a visceral device designed specifically for downtuned guitar and bass.

Designed in collaboration with Nick Williams of Dunwich Amplification.

 

The traditional HM-2 Level, Low EQ, and High EQ settings are maxed internally, with the single Grief knob controlling Distortion.

An increased and extended Low EQ combines with a modified High EQ for a pummeling chainsaw dirge with reduced high frequency harshness.

Controls

Grief: Distortion.

Set the Grief knob towards zero and run the Doomsaw gyrating EQ into a high gain amplifier or your favorite fuzz / distortion pedals.

Set the Grief knob towards max and run it as your primary distortion pedal for unrivaled dimed Doomsaw fury.

Power

Use only a standard 9v DC power supply with a 2.1mm negative-center barrel. An isolated power supply is recommended. Power supply not included.

Specs

  • One-knob modified chainsaw distortion for guitar and bass
  • Relay-based, true bypass soft switching
  • Adjustable LED brightness via internal trim pot (LED BRIGHTNESS)
  • Premium components including Neutrik input/output jacks, Lumberg power jack, ORMAT knob, Alpha pot, sealed relay, metal LED bezel, and mil-spec aircraft grade wire
  • Powder coated finish with clear coat and high gloss textured UV printed artwork in aged HM-2 orange
  • 4.75” x 2.625” x 2.375”
  • 8.8oz
More Information
Manufacturer Does It Doom
Condition New
Write Your Own Review
You're reviewing:Does It Doom Doomsaw HM-2 Heavy Metal Chainsaw Distortion